>
General |
1. |
Basically, all measurements in this manual are taken with a tracking gauge. |
2. |
When a measuring tape is used, check to be sure there is no elongation, twisting or bending. |
3. |
For measuring dimensions, both projected dimension and actual-measurement dimension are used in this manual. |
Measurement method |
Projected dimensions |
1. |
These are the dimensions measured when the measurement
points are projected into the reference plane, and are the reference
dimensions used for body alterations. |
2. |
If the length of the tracking gauge probes are adjustable,
make the measurement by lengthening one probe by the amount equivalent
to the difference in height of the two surfaces. |
Actual-measurement dimensions |
1. |
These dimensions indicate the actual linear distance between
measurement points, and are the reference dimensions for use if a
tracking gauge is used for measurement. |
2. |
Measure by first adjusting both probes to the same length (A=A')
|
Measurement point |
1. |
Measurements should be taken at the hole center. |
Components and Components Location
Component Location
1. Fuel filler door open switch2. Fuel filler door release actuator
...
Before starting
Close and lock all doors.
Position the seat so that all controls are easily reached.
Adjust the inside and outside rearview mirrors.
Be sure that all lights work.
Check all gauges.
Check ...
Specifications
Specifications
ItemsSpecificationRated voltageDC 12VOperating voltage9V ~ 16VOperating speed15x/h ~ 250x/hSensible distance70m (Sedan)Curvature radiusStart : More than 100mStop : Less than 70mFre ...