>
Description |
Description | Specification | |
Operating voltage | 8 ~ 16V | |
Operating temperature | -40 ~ 85°C | |
Current consumption | Max.150mA | |
Measuring range | Angle | -900 ~ 900° |
Angular velocity | 0 ~ 1016°/sec |
- |
Replacement of the Steering Wheel Angle Sensor |
- |
Replacement or repair of the Steering column |
- |
Detection of DTC codes (C1260, C1261) |
- |
Replacement of the sensor cluster |
- |
Replacement of HECU |
1. |
Connect the GDS.(CAN line or OBD connector) |
2. |
Turn ignition switch on. |
3. |
Press calibration button of the Steering Wheel Angle Sensor. |
4. |
HECU calibration procedure is performed.
(Calibration records, DTC codes erasure) |
5. |
Turn ignition switch off after calibration procedure. |
6. |
Confirm success or failure of calibration.
|
Instrument Cluster Control
Adjusting Instrument Cluster Illumination
The brightness of the instrument panel illumination can be adjusted by pressing
the illumination control buttons (“+” or “-”) when the Engine Start/Sto ...
System operation
Ventilation
1. Set the mode to the position.
2. Set the air intake control to the outside (fresh) air position.
3. Set the temperature control to the desired position.
4. Set the fan speed contro ...
Relay Box (Engine Compartment) Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Pull out the relay from the engine compartment relay box.
Power Relay (Type A)
-
Do not use pliers.
...