>
Removal |
1. |
Remove the connector after removing the front wheel speed sensor clip. |
2. |
Remove the front wheel speed sensor.
(Refer to Driveshaft and Axle - "Front Axle Assembly") |
3. |
Installation is the reverse of removal. |
Inspection |
1. |
Measure the output voltage between the terminal of the wheel speed sensor and the body ground.
|
2. |
Compare the change of the output voltage of the wheel speed sensor to the normal change of the output voltage as shown below.
|
Mode Control Actuator Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the mode control actuator connector.
3.
Verify that the mode control actuator operates to the defrost mode when connecting 12V to ...
Storage compartments
These compartments can be used to store small items required by the driver or
passengers.
CAUTION
To avoid possible theft, do not leave valuables in the storage compartments.
Always keep the ...
Crankshaft Position Sensor (CKPS) Specifications
Specification
ItemSpecificationCoil Resistance (x)774 ~ 946 [20°C (68°F)]Air cap(mm)0.5 ~ 1.5
...