>
Removal |
1. |
Release the parking brake by pushing the EPB switch. |
2. |
Turn ignition switch off and disconnect the battery (-) cable from the battery. |
3. |
Remove the canister service cover in the trunk. |
4. |
Remove the canister and the bracket.
(Refer to Emission Control System - “Canister”) |
5. |
Remove the canister bracket (A).
|
6. |
Disconnect the EPB connector (A). |
7. |
Remove the EPB bracket No. 2 after removing the bolt.
|
8. |
Remove the rear brake disc.
( Refer to Brake System - "Rear Disc Brake”) |
9. |
Remove the parking brake cable after removing the bolt (A).
|
10. |
Remove the parking brake cable (A) from the DIH operating lever assembly. (Both left and right side) |
11. |
Remove the mounting bolt for parking brake cable.
|
12. |
Remove the EPB bracket No. 1 mounting bolt.
|
13. |
Remove the EPB and the bracket No. 2 from the sub flame. |
14. |
Remove the EPB from the bracket No. 2 after mounting nut (A).
|
Installation |
1. |
Installation is reverse of removal. |
2. |
Adjust the rear brake shoe clearance.
|
3. |
Check that the brake operates normally by pushing the EPB switch more than 3 times after installing the EPB module.
|
Front Hub / Knuckle / Tone Wheel Components and Components Location
Component location
1. Front knuckle assembly2. Hub assembly3. Dust cover4. Brake disc
...
Temperature Control Actuator Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the temperature control actuator connector.
3.
Verify that the temperature control actuator operates to the
warm (Driver's side) ...
Rear Wheel House Trim Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protec ...