>
Removal |
1. |
Remove the lower crash pad.
(Refer to Body - "Crash Pad") |
2. |
Disconnect the stop lamp switch connector (A). |
3. |
Remove the mounting bracket nut (B).
|
4. |
Remove the snap pin (A) and clevis pin (B). |
5. |
Remove the brake pedal member assembly mounting nuts (C) and then remove the brake pedal assembly.
|
Inspection |
1. |
Check the bushing for wear. |
2. |
Check the brake pedal for bending or twisting. |
3. |
Check the brake pedal return spring for damage. |
4. |
Check the stop lamp switch.
|
Blower Unit Components and Components Location
Component Location
Components
1. Intake Duct Case2. Intake Duct Case (A)3. Intake Door4. Intake Actuator5. Seal6. Blower Upper Case7. Blower Lower Case8. Seal9. Climate Control Air Filter Cover1 ...
Crash Pad Side Cover Components and Components Location
Component Location
[LH]
1. Crash pad side cover [LH]
[RH]
1. Crash pad side cover [RH]
...
Master Cylinder Components and Components Location
Components
1. Reservoir cap2. Reservoir3. Grommet4. Cylinder pin5. Retainer6. Primary piston assembly7. Secondary piston assembly8. Master cylinder body
...