>
To program a device to HomeLink® using a HomeLink® button previously trained, follow these steps:
1. Press and hold the desired HomeLink® button. DO NOT release the button.
2. The indicator light will begin to flash after 20 seconds. Without releasing the
HomeLink® button, proceed with "Programming" step 2.
Sunroof Switch Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Open the sunglass case cover from the overhead console then
remove the 2 screws holding the overhead console. Disconnect the sw ...
Driving your vehicle
WARNING - ENGINE EXHAUST CAN BE DANGEROUS!
Engine exhaust fumes can be extremely dangerous. If, at any time, you smell
exhaust fumes inside the vehicle, open the windows immediately.
Do not inh ...
Parking Assist Sensor Repair procedures
Removal
[Front Bumper]
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the connector from the front bumper cover.
(Refer to Body - "Front Bumper Cover")
3.
Pull out the se ...