>
Removal |
1. |
Disconnect the battery negative cable, and wait for at least three minutes before beginning work. |
2. |
Remove the front seat assembly.
(Refer to Body - "Front Seat Assembly") |
3. |
Remove the front seat outer shield cover.
(Refer to Body - "Front Seat Outer Shield Cover") |
4. |
Disconnect the EFD system connector. |
5. |
Unscrew the mounting bolt from the front seat assembly, and then remove the EFD system (A). |
Installation |
1. |
Disconnect the negative (-) cable from battery and wait for at least three minutes. |
2. |
Install the EFD system with the mounting bolt.
|
3. |
Connect the EFD system connector. |
4. |
Install the front seat shield outer cover.
(Refer to Body - "Front Seat Outer Shield Cover") |
5. |
Install the front seat assembly.
(Refer to Body - "Front seat assembly")
|
6. |
Reconnect the battery negative cable. |
7. |
After installing the EFD system, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off. |
Front Bumper Cover Components and Components Location
Component Location
1. Front bumper cover
...
Components and Components Location
Component Location
1. Fuel filler door open switch2. Fuel filler door release actuator
...
Photo Sensor Repair procedures
Inspection
1.
Turn the ignition switch ON.
2.
Connect the GDS.
3.
Emit intensive light toward the photo sensor using a lamp, and check the output voltage change.
4.
The voltage will ri ...