>
Removal |
1. |
Disconnect the battery negative cable and wait for at least three minutes before beginning work. |
2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel") |
3. |
Remove the knee airbag (C) after loosening the srcrews (A) and nuts (B). |
Installation |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the battery negative cable and wait for at least three minutes. |
3. |
Tighten the knee airbag mounting screws (A) and nuts (B).
|
4. |
Install the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel") |
5. |
Reconnect the battery negative cable. |
6. |
After installing the knee airbag, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off. |
Checking the washer fluid level
The reservoir is translucent so that you can check the level with a quick visual
inspection.
Check the fluid level in the washer fluid reservoir and add fluid if necessary.
Plain water may be ...
Parking Assist Sensor Schematic Diagrams
Circuit diagram
...
Engine And Transmission Assembly Repair procedures
Removal
•
Use fender covers to avoid damaging painted surfaces.
•
To avoid damage, unplug the wiring connectors carefully while holding the connector portion.
...