>
Removal |
1. |
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work. |
2. |
Remove the roof trim assembly.
(Refer to Body - "Roof Trim Assembly") |
3. |
Disconnect the curtain airbag harness connector. |
4. |
After loosening the mounting bolts remove the curtain airbag. |
Installation |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the battery negative cable and wait for at least three minutes. |
3. |
Tighten the curtain airbag mounting bolts.
|
4. |
Connect the curtain airbag connector. |
5. |
Install the roof trim assembly.
(Refer to Body - "Roof Trim Assembly") |
6. |
Reconnect the battery negative cable. |
7. |
After installing the curtain airbag (CAB), confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off. |
Front wiper deicer
If your vehicle is equipped with the front wiper deicer, it will be operating
at the same time you operate the rear window defroster. ...
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Specifications
Specifications
Direct control VFS[UD/C]
x Control type : Normal low type
Control Pressure kpa (kgf/cmx, psi)0~1569.06 (0~16,0~227.57)Current value(mA)0~1100 Internal resistance ...
Rear Right Door Module (RRDM) Components and Components Location
Component
...