>
Removal |
1. |
Disconnect the battery negative cable and wait for at least three minutes before beginning work. |
2. |
Remove the glove box housing.
(Refer to Body - "Glove Box Housing") |
3. |
Disconnect the passenger airbag connector (A) and remove the mounting bolts (B). |
4. |
Remove the crash pad.
(Refer to Body - "Main Crash Pad Assembly")
|
5. |
Remove the mounting bolts (A) from the crash pad. Then remove the passenger airbag.
|
Installation |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the battery negative cable from battery and wait for at least three minutes before beginning work. |
3. |
Place a passenger airbag on the crash pad and tighten the passenger airbag mounting bolts (A).
|
4. |
Install the crash pad.
(Refer to Body - "Main Crash Pad Assembly") |
5. |
Tighten the passenger airbag mounting bolts (B).
Connect the passenger airbag harness connector (A) to the SRS main harness connector.
|
6. |
Reinstall the glove box housing.
(Refer to Body - "Glove Box Housing") |
7. |
Reconnect the battery negative cable. |
8. |
After installing the passenger airbag, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off. |
Headlight, position light, turn signal light, side marker light and front fog
light bulb replacement
(1) Position light
(2) Headlight (High)
(3) Headlight (Low)
(4) Front side marker light
(5) Front turn signal light
(6) Front fog light
1. Open the hood.
2. Disconnect the negative battery ...
Rear Door Window Glass Components and Components Location
Component Location
1. Rear door window glass
...
Engine Control Module (ECM) Schematic Diagrams
ECM Terminal And Input / Output signal
ECM Harness Connector
ECM Terminal Function
Connector [C200-A]
Pin No.DescriptionConnected to1Ignition Coil (Cylinder #3) control outputIgnition Coil ( ...