>
Removal |
1. |
Disconnect the battery negative cable, and wait for at least three minutes before beginning work. |
2. |
Remove the front seat assembly.
(Refer to Body - "Front Seat Assembly") |
3. |
Remove the seat belt buckle switch.
(Refer to Body - "Front Seat Belt Buckle") |
Installation |
Be sure to install the harness wires so they will not pinch or interfere with other parts.
|
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the battery negative cable, and wait for at least three minutes before beginning work. |
3. |
Install the seat belt buckle switch.
(Refer to Body - "Front Seat Belt Buckle") |
4. |
Install the front seat assembly.
(Refer to Body - "Front Seat Assembly") |
5. |
Reconnect the battery negative cable. |
6. |
After installing the seat belt buckle switch, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator should turn on for about six seconds and then go off. |
Rear Bumper Beam Assembly Components and Components Location
Component Location
1. Rear bumper beam assembly
...
Emergency towing
If towing is necessary, we recommend you to have it done by an authorized EQUUS
dealer or a commercial tow truck service.
If towing service is not available in an emergency, your vehicle may be t ...
Emission control system
The emission control system of your vehicle is covered by a written limited warranty.
Please see the warranty information contained in the Owner’s Handbook & Warranty
Information booklet in yo ...