>
Removal |
|
1. |
Disconnect the battery negative cable, and wait for at least three minutes before beginning work. |
2. |
Remove the front door trim.
(Refer to Body - "Front Door Trim") |
3. |
Disconnect the front side impact sensor connector (A), and
then remove the front side impact sensor mounting screws to remove the
sensor (B). |
1. |
Disconnect the battery negative cable and wait for at least three minutes before beginning work. |
2. |
Remove the rear wheel house trim.
(Refer to Body - " Rear Wheel House Trim") |
3. |
Disconnect the rear side impact sensor connector (A), and
then loosen the rear side impact sensor mounting bolt to remove the rear
side impact sensor (B). |
Installation |
Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
|
1. |
Install the new front side impact sensor with the screws, then connect the front side impact sensor connector.
|
2. |
Install the front door trim.
(Refer to Body - "Front Door Trim") |
3. |
Reconnect the battery negative cable. |
4. |
After installing the front side impact sensor, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off. |
1. |
Install the new rear side impact sensor with a bolt and then connect the rear side impact sensor connector.
|
2. |
Install the rear wheel house trim.
(Refer to Body - "Rear Wheel House Trim") |
3. |
Reconnect the battery negative cable. |
4. |
After installing the rear side impact sensor, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off. |
Cup holder
WARNING - Hot liquids
Do not place uncovered cups of hot liquid in the cup holder while the
vehicle is in motion. If the hot liquid spills, you could be burned. Such a
burn to the driver cou ...
Checking the coolant level
WARNING Removing radiator cap
Never attempt to remove the radiator cap while the engine is operating
or hot. Doing so might lead to cooling system and engine damage and could result
in ser ...
ECU Schematic Diagrams
Circuit diagram
1.
ECU Connector
2.
ECU Terminal function
TerminalFunction1Ground2Ground3IGN4Battery5Battery6-7-8-9-10-11-12Reverse Valve 1x(M1 Low Side)13Ambiance Valve14Reverse Valve 2x( ...