>
Removal |
|
1. |
Disconnect the battery negative cable, and wait for at least three minutes before beginning work. |
2. |
Remove the radiator assembly.
(Refer to Engine Mechanical System - "Radiator") |
3. |
Disconnect the front impact sensor connector (A), and them loosen the nuts to remove the front impact sensor (B).
[Driver's side]
[Passenger's side] |
Installation |
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
|
1. |
Install a new front impact sensor. |
2. |
Tighten the front impact sensor mounting nut.
|
3. |
Connect the front impact sensor connector. |
4. |
Install the radiator assembly. |
5. |
Reconnect the battery negative cable. |
6. |
After installing the front impact sensor, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off. |
Relay Box (Engine Compartment) Components and Components Location
Component Location
...
Checking the coolant level
WARNING Removing radiator cap
Never attempt to remove the radiator cap while the engine is operating
or hot. Doing so might lead to cooling system and engine damage and could result
in ser ...
Rear Remote Controller (RRC) Repair procedures
Removal
Rear Keyboard Unit
1.
Remove the rear seat armrest upper cover.
(Refer to Seat Electrical System - "Seat Heater Switch")
2.
Disconnect the connectors (A) from armrest upper cover.
...