✽ NOTICE
- When programming a garage door opener, it is advised to park the vehicle
outside of the garage. • It is recommended that a new battery be placed in the
hand-held transmitter of the device being programmed to HomeLink® for quicker
training and accurate transmission of the radio-frequency signal.
- Some vehicles may require the ignition switch to be turned to the second
(or "accessories") position for programming and/or operation of HomeLink. •
In the event that there are still programming difficulties or questions after
following the programming steps listed below, contact HomeLink® at: www.homelink.com
or 1-800-355-3515.
The Compass can be turned ON and OFF and will remember the last state when the
ignition is cycled. To turn the display feature ON/OFF:
1. Press and release the button
within 1 second to turn the ...
To train most devices, follow these instructions:
1. For first-time programming, press and hold the two outside buttons (
,
), HomeLink® Channel 1 and Channel 3, until the indicator light begins ...
See also:
G Sensor Schematic Diagrams
Circuit diagram
1.
G-sensor connector
2.
G-sensor terminal function
NoFunction1Signal2Ground3Power(5V)
3.
Circuit diagram ...
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
Repair procedures
Inspection
Initialization and diagnosis sequence by using diagnostic equipment
Below content summarize the procedure for A/S using Diagnostic equipment
Download Parameter
1.
Select "AFLS" menu ...