>
Component Replacement after Deployment |
Before doing any SRS repairs, use the GDS to check for DTCs.
Refer to the Diagnostic Trouble Code list for repairing of the related
DTCs. |
- |
SRSCM |
- |
Deployed airbag(s) |
- |
Seat belt pretensioner(s) |
- |
Front impact sensors |
- |
SRS wiring harnesses |
- |
Inspect the clock spring for heat damage.
If any damage found, replace the clock spring.
|
- |
SRSCM |
- |
Deployed airbag(s) |
- |
Side impact sensor(s) for the deployed side(s) |
- |
SRS wiring harnesses
|
- |
Turn the ignition switch ON; the SRS indicator should come on for about six seconds and then go off. |
Repair procedures
Removal
1.
Remove the steering column upper and lower shrouds after loosening screws.
2.
Disconnect the multifunction switch connector (A).
3.
Remove the wiper & washer switch (A) by p ...
Seat belt restraint system
WARNING
For maximum restraint system protection, the seat belts must always be
used whenever the car is moving.
Seat belts are most effective when seatbacks are in the upright position.
Chi ...
Battery Specifications
Specifications
ItemSpecificationModel typeCMF100L-DINCapacity [20HR/5HR] (AH)100/80 Cold Cranking Amperage (A)780 (SAE) /624 (EN)Reserve Capacity (Min)190
...