>
Warning Lamp Activation |
Warning Lamp Behavior after Ignition On |
1. |
Active fault or historical fault counter is greater or equal to 10. |
2. |
Normal or historical fault counter is less than 10. |
3. |
When turning the ignition switch ON during variant coding
(EOL) mode, the airbag warning lamp is turned on and blinks at intervals
of 1 second till the coding is completed.
In case the variant coding is normally completed, the airbag
warning lamp is turned on for 6 seconds, and then turned off. Otherwise
the airbag warning lamp continuously blinks at intervals of 1 second.
When there is active fault in the airbag system or SRSCM
internal fault, the variant coding (EOL) cannot be completed. In this
case, do the variant coding (EOL) procedure again after troubleshooting
with the GDS. |
1. |
Loss of battery supply to the SRSCM : warning lamp is turned on continuously. |
2. |
Loss of internal operating voltage : warning lamp is turned on continuously. |
3. |
Loss of microprocessor operation : warning lamp is turned on continuously. |
4. |
SRSCM not connected : warning lamp is turned on continuously. |
Occupant Status | Telltale Lamp | PAB |
Empty | ON | Disabled |
Child (Small Occupant) | ON | Disabled |
Adult (Large Occupant) | OFF | Enabled |
Defect | OFF | Enabled |
Climate Control Air Filter Description and Operation
Description
The climate control air filter is located in the blower unit.
It eliminates foreign materials and odor. The particle filter performs a
role as an odor filter as well as a conventio ...
Rear Wheel Speed Sensor Repair procedures
Removal
1.
Remove the rear wheel speed sensor mounting bolt.
Tightening torque:
6.9 ~ 10.8 Nm (0.7 ~ 1.1 kgf.m, 5.1~ 8.0 lb-ft)
2.
Remove the rear wheel guard.
3.
Disconnect the rea ...
Front Pillar Trim Components and Components Location
Component Location
1. Front pillar trim
...