>
Removal |
[Front Stabilizer Bar] |
1. |
Removal the front wheel & tire.
|
2. |
Disconnect the stabilizer link (A) from the front strut assembly by loosening the nut.
|
3. |
Disconnect the stabilizer bar (A) from the front sub frame by loosening the bolt.
|
4. |
Installation is the reverse of removal. |
[Rear Stabilizer Bar] |
1. |
Remove the rear wheel & tire.
|
2. |
Disconnect the rear stabilizer link (A) from the rear lower arm by loosening the nut.
|
3. |
Loosen the mounting bolt and then remove the stabilizer bar (A).
|
4. |
Installation is the reverse of removal. |
Inspection |
1. |
Check the bushing for wear and deterioration. |
2. |
Check the ball joint for rotating torque. |
Buzzer Description and Operation
Description
Buzzer ouput the warning sound of PAS.
PAS output the buzzer sound and warning sound. Cluster speaker makes buzzer sound, but externer AV AMP makes warning sound. ...
Door Scuff Trim Repair procedures
Replacement
[Front Door Scuff Trim]
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protect ...
Front Wheel Speed Sensor Repair procedures
Removal
1.
Remove the connector after removing the front wheel speed sensor clip.
2.
Remove the front wheel speed sensor.
(Refer to Driveshaft and Axle - "Front Axle Assembly")
3.
Install ...