>
Removal |
|
1. |
Remove the front bumper.
(Refer to Body- "Front Bumper Cover") |
2. |
Remove the left head lamp.
(Refer to Body Electrical System- "Head Lamps") |
3. |
Disconnect the connector (B) and nut (A-2ea) remove the G-sensor (C).
|
4. |
Install in the reverse order of removal. |
1. |
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Exhaust Manifold") |
2. |
Disconnect the connector (B) and nut (A-2ea) remove the G-sensor (C).
|
3. |
Install in the reverse order of removal. |
1. |
Remove the trunk trim.
(Refer to Body - "Trunk Trim") |
2. |
Remove the luggage side trim on the left.
(Refer to Body - "Trunk Trim") |
3. |
Loosen the bolt (A-2ea) and bracket nut (B-2ea) and disconnect connector (C) remove the G-sensor (D).
|
4. |
Install in the reverse order of removal. |
Power Trunk (if equipped)
(1) Power Trunk Main Control button
(2) Power Trunk Open button
(3) Power Trunk Close button
(4) Power Trunk Lock button
To open:
1. Make sure the shift lever is in P(Park).
2. Then do one o ...
Crach Pad Center Panel Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply prote ...
Detecting sensor
The sensors are located inside of the rear bumper.
Always keep the rear bumper clean for the system to work properly. ...