The compressor operates in all events except the system air
filling and two solenoid valves (referred to as reverse valve, on-off
control, and normal open) are embedded.
Air dryer is maintenance free (permanent use).The relief
valve opens upon the pressure of 20±3bar.The compressor relay is
monitored by control module in order to detect any failure in relay. If
the compressor relay is failed (short to battery, short to ground or
open circuit), the lifting is prohibited but down leveling is only
available. However, the down leveling is done not by compressor but
ambient valve.
Components
1. Dyer2. Motor3. Connected to tube4. Reverse valve connector5. Connector for motor driveing
...
Circuit diagram
1.
Air compressor connector
[Motor power connector (A)][Exhaust valve connector (B)][Temperature sensor connector (C)]
2.
Air compressor terminal function
[Motor power]
...
See also:
Heater Control Unit Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the cowl side trim.
(Refer to Body - "Cowl Side Trim")
3.
To remove the crash pad under cover [RH] (A), press both ...
Components and Components Location
Component Location
1. Fender assembly
...
Programming
To train most devices, follow these instructions:
1. For first-time programming, press and hold the two outside buttons (
,
), HomeLink® Channel 1 and Channel 3, until the indicator light begins ...