>

Hyundai Equus: Front Air Strut Assembly Troubleshooting - Air Suspension System - Suspension System - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Front Air Strut Assembly Troubleshooting

Variable damper (CDC) failure criterion
Conditions
Phenomena
Maintenance considerations
Mechanical conditions
Leaking oil
An oil leak indicates that the part has failed and must be replaced.
Inner seam occurs
An inner seam indicates that the part has failed and must be replaced.
Damaged connector
Replace any damaged electrical connectors.
Excessive distortion
Replace the applicable parts.
Electric conditions
DTC code occurs:
C2203/C2204/C2205/C2206 
Use a multitester to test the voltage at the two pins (1, 2) of the connector (check the connector for an open circuit).
Replace the damper if you detect an open circuit in the damper.
If the connections inside the damper are good, check the connection between the damper and body-side connector before reconnecting the connector.
If faults remain, remove the ECS ECU connector on the left side of the trunk, and then check the relevant pins for open or short circuits (also check the damper side for disconnections).
Take the proper measures according to the cause of the failure. Then, re-check the DTC code (in startup condition).

    Front Air Strut Assembly Schematic Diagrams
    Circuit Diagram 1. Front air strut connector 2. Front air terminal function TerminalFunction1Variable damper (-)2Variable damper (+) 3. Circuit diagram ...

    Front Air Strut Assembly Repair procedures
    Removal Air Strut Assembly     • Before replacing the relevant parts, use GDS equipment to fully discharge the air from the relevant parts. (Refer to Air Suspension System - ...

    See also:

    Filter inspection
    The climate control air filter should be replaced every 15,000 miles (24,000 km). If the vehicle is operated in severely air-polluted cities or on dusty rough roads for a long period, it should be ...

    Unlocking
    To unlock: 1. Carry the Smart Key. 2. Either put your hand in the driver’s outside door handle or press the Door Unlock button on the Smart Key. 3. The driver’s door will unlock. The hazard w ...

    Fuel Pressure Control Valve Description and Operation
    Description Fuel Pressure Control Valve is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on vario ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com