>
Removal |
1. |
Remove the front wheel and tire (A) from front hub .
|
2. |
Loosen the flange bolt (A) & lock nut (B).
|
3. |
Unscrew the flange bolt (A) and lock nut (B) to disconnect the lateral arm (C) from the strut assembly (D).
|
4. |
Remove the split pin (A) and castle nut (B).
|
5. |
Apply grease to the special tool (09568-2J100), as shown in
the following figure. Then, use the special tool to disconnect the
lateral arm (A) from the knuckle. |
6. |
Install in the reverse order of removal. |
7. |
Check the front alignment.
(Refer to Tires/Wheels - "Alignment") |
1. |
Disconnect the pin and castle nut from the tie-rod end (A) and tension arm (B).
|
2. |
Apply grease to the special tool (09568-2J100), as shown in
the following figure. Then, use the special tool to remove the tie-rod
end (A) and tension arm (B) from the knuckle. |
3. |
Disconnect the flange bolt and lock nut to remove the tension arm (A) from the frame.
|
4. |
Install in the reverse order of removal. |
5. |
Check the alignment.
(Refer to Tires/Wheels - "Alignment")
|
Inspection |
1. |
Check the lower arm bushings for damage or signs of aging. If necessary, replace the lower arm assembly. |
2. |
Chech the lower arm for deformation. |
3. |
Check the all bolts. |
Specifications
Specifications
ItemSpecificationSteering GearTypeRack & PinionRack strokeManual144mmAIR136mmPower Steering MotorTypeBLDC (WET type)Voltage13.5VSteering angle (Max.)InnerR17Manual42.67°±1°30’A ...
Description and Operation
Description
Refer to the "Body Network System" for the abbreviation information. ...
Rear window defroster
The defroster heats the window to remove frost, fog and thin ice from the rear
window, while the engine is running.
To activate the rear window defroster, press the rear window defroster button ...