>
Removal |
1. |
Remove the front wheel and tire (A) from front hub .
|
2. |
Remove the front assembly.
(Refer to Front Suspension System - "Front Strut Assembly") |
3. |
Disconnect the front upper arm (A) with the front strut assembly bracket (B) by loosening the bolt.
|
4. |
Installation is the reverse of removal.
|
5. |
Check the alignment.
(Refer to Tires/Wheels - "Alignment")
|
Inspection |
1. |
Check the bushing for wear and deterioration. |
2. |
Check the ball joint for rotating torque. |
Heater Unit Components and Components Location
Component Location
Components
1. Heater Case (Left)2. Vent Door (Left)3. Temperature Door (Left)4. Floor Door (Left)5. Console Temperature Control Actuator (A) 6. Console Temperature Lever7. Con ...
Components and Components Location
Component Location
1. Engine room relay box (Rear glass defogger)2. Rear window defogger switch (A/C controller)3. Rear window defogger4. Body control unit
...
Intake Actuator Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the intake actuator connector.
3.
Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 ...