Hyundai Equus: ON/OFF Solenoid Valve Description and Operation
Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / ON/OFF Solenoid Valve Description and Operation
Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / ON/OFF Solenoid Valve Description and Operation
| Description |
ON/OFF solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears.
Damper Clutch Control Solenoid Valve Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the resi ...
ON/OFF Solenoid Valve Specifications
Specifications
ON/OFF Solenoid Valve
x Control type : Normal low type
Control pressure kpa (kgf/cmx, psi)539.36(5.5, 78.23) Internal resistance(x)10~11
...
See also:
Troubleshooting
Troubleshooting
SymptomProbable causeRemedyExcessive play in steeringLoose yoke plugRetightenLoose steering gear mounting boltsRetightenLoose or worn tie rod endRetighten or replace as necessaryS ...
Knee Airbag (KAB) Module Description and Operation
Description
The Knee Airbag (KAB) is installed inside the crash pad lower
panel and protects the driver in the event of a frontal crash. The
SRSCM determines if and when to deploy the KAB.
...
Lumbar Support Unit Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear seat back.
(Refer to Body - "Rear Seat Back Cover")
3.
Remove the bladder & ECU/ valve assembly (A) after l ...
Categories
Hyundai Equus Manuals
© 2011-2024 Copyright www.heqmanual.com