>
Inspection |
1. |
Turn ignition switch OFF. |
2. |
Disconnect the E Module connector. |
3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
4. |
Check that the resistance is within the specification. |
Troubleshooting
Troubleshooting
•
Check the fuel pressure after replacing parts.
(Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line")
...
Head Up Display Setting
On the LCD display, you can change the head up display settings as follows.
1. Display height
2. Illumination
3. Font color
4. Font size
5. Contents setting ...
Rear combination lamp Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Loose the nuts holding the rear combination lamp (outside) then disconnect the connector (A).
3.
Remove the rear combination la ...