>
Inspection |
TCM Problem Inspection Procedure |
1. |
TEST TCM GROUND CIRCUIT: Measure resistance between TCM and
chassis ground using the backside of TCM harness connector as TCM side
check point. If the problem is found, repair it.
|
2. |
TEST TCM CONNECTOR: Disconnect the TCM connector and visually
check the ground terminals on TCM side and harness side for bent pins
or poor contact pressure. If the problem is found, repair it. |
3. |
If problem is not found in Step 1 and 2, the TCM could be
faulty. If so, make sure there were no DTC's before swapping the TCM
with a new one, and then check the vehicle again. If DTC's were found,
examine this first before swapping TCM. |
4. |
RE-TEST THE ORIGINAL TCM: Install the original TCM (may be broken) into a known-good vehicle and check the vehicle.
If the problem occurs again, replace the original TCM with a
new one. If problem does not occur, this is intermittent problem (Refer
to “Intermittent Problem Inspection Procedure” in Basic Inspection
Procedure).
|
Replacement |
1. |
Turn ignition switch OFF. |
2. |
Disconnect the negative (-) battery cable. |
3. |
Disconnect the ECM connector (A) and TCM connector (B). |
4. |
Remove the TCM & ECM after removing the bolts (C) and nut (D).
|
5. |
Remove the TCM (B) after removing the bolts (A). |
Installation |
1. |
Installation is reverse of removal.
|
Components and Components Location
Component Location
1. Start Stop Button(SSB)2. FOB key3. Trunk open switch4. RF receiver5. Interior antenna 16. Interior antenna 27. Interior antenna 38. Trunk antenna9. Door handle & do ...
Changing the engine oil and filter
Have engine oil and filter changed by an authorized EQUUS dealer according to
the Maintenance Schedule at the beginning of this section.
CALIFORNIA PROPOSITION 65 WARNING
Engine oil contains c ...
Solenoid Valve Repair procedures
Removal
•
Before replacing the relevant parts, use GDS equipment to fully discharge the air from the relevant parts.
(Refer to Air Suspension System - "Repair procedures ( ...