>
Removal |
1. |
Disconnect (-) terminal from the battery.
|
2. |
Remove the under cover (A). |
3. |
Remove the under cover (A). |
4. |
Remove the stay (A) and (B). |
5. |
Disconnect the ground wire (A) by removing the bolt. |
6. |
Remove the propellar shaft assembly (A).
(Refer to "Propellar shaft" in DS group) |
7. |
Remove the oil cooler tubes. |
8. |
Disconnect the inhibitor switch connector (B). |
9. |
Remove the nut (C) and clip (D). |
10. |
Remove the shift cable (A). |
11. |
Disconnect the solenoid valve connector (A) and the oxygen sensor connector (B). |
12. |
Remove the CKP sensor (A) itself and the brackets for wire. |
13. |
Remove the dust cover (A). |
14. |
Remove the torque converter mounting bolts (A-6ea) by rotating the crank shaft.
|
15. |
Using a jack support the transmission assembly. |
16. |
Remove the mounting bolts (A-4ea) lower in the engine side.
|
17. |
Remove the mounting bolt (A-1ea, B-2ea) left in the transmission side.
|
18. |
Remove the cross member (A) by removing bolts.
|
19. |
Remove the mounting bolts (A-2ea) for the starter motor. |
20. |
Remove the mounting bolt (B-1ea).
|
21. |
Remove the mounting bolts (A-2ea) on the transmission side.
|
22. |
Remove the tansmission assembly by lowering the supporting jack.
|
Installation |
1. |
Install in the reverse order of removal.
|
2. |
In case of the reinstallation.
|
3. |
In case of the replacing with a new automatic transaxle.
|
4. |
In case of the replacing with a remanufactured automatic transaxle.
|
Smart Key Unit Repair procedures
Removal
Smart Key Unit
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel after loosening the mounting screws.
(Refer to Body - "Crash Pad Lower Panel")
...
Distance to distance vehicle sensor
The sensor detects distance to the vehicle ahead.
If the sensor is covered with dirt or other foreign matter, the vehicle to vehicle
distance control may not operate correctly.
Always keep the ...
Brake Line Repair procedures
Removal
1.
Remove the wheel & tire.
2.
Remove the brake hose clip (A).
Front
Rear
3.
Disconnect the brake tube by loosening the tube flare nut.
Tightening torque :
12.7 ~ 16.7 N ...