>
Removal |
In case of removing the high pressure fuel pump, high
pressure fuel pipe, delivery pipe, and injector, there may be injury
caused by leakage of the high pressure fuel. So don’t do any repair
work right after engine stops.
|
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Release the residual pressure in fuel line (Refer to “Release Residual Pressure in Fuel Line” in this group).
|
3. |
Disconnect the injector connector (A). |
4. |
Remove the intake manifold (Refer to "Intake And Exhaust System" in EM group). |
5. |
Remove the pump foam (A).
[Bank 1]
[Bank 2] |
6. |
Remove the high pressure fuel pipe (A).
[Bank 1]
[Bank 2] |
7. |
Remove the injector foam (A). |
8. |
Remove the rail pressure sensor connector (A). |
9. |
Remove the installation high pressure fuel pipe plange nut
(B) from the high pressure fuel pipe with the special service tool [SST
No.: 09314-3Q100 or 09314-27130]. |
10. |
Remove the cross over fuel pipe (C). |
11. |
Remove the installation bolt (D), and then remove the delivery pipe and injector assembly from the engine. |
Installation |
|
|
|
|
|
1. |
Install in the reverse order of removal.
|
General Safety Information and Caution
Smart Cruise Control
Be careful when driving the vehicle using the smart cruise control system as follows.
•
The smart cruise control system may have limits to detect dist ...
Cool and Warm Box Components and Components Location
Component Location
1. Cool & Warm Box Bracket2. Wire Harness3. Front Duct4. Cool & Warm Box Assembly5. Wire Harness6. Cool & Warm Box Partition7. Circuit Board Cover8. Circuit Board9. ...
Front Washer Motor Repair procedures
Removal
1)
When servicing the washer pump, be careful not to damage the washer pump seal.
2)
Do not operate the washer pump before filling the washer reservoir.
Failure ...