>
Inspection |
1. |
Connect the GDS on the Data Link Connector (DLC). |
2. |
Check the output voltage of fuel pressure sensor (FPS).
|
Removal |
1. |
Turn ignition switch OFF and disconnect the negative (-)battery cable. |
2. |
Folding the rear seat cushion. |
3. |
Remove the fuel pump service cover (A) after loosening the screws. |
4. |
Disconnect the fuel pressure sensor connector (A). |
5. |
Remove the fuel pressure sensor fixing pin (B) in the direction of the arrow . |
6. |
Remove the fuel pressure sensor (C) from the fuel pump. |
Installation |
1. |
Install in the reverse order of removal. |
For best battery service
The battery is in the trunk.
Keep the battery securely mounted.
Keep the battery top clean and dry.
Keep the terminals and connections clean, tight, and coated with petroleum
jelly or t ...
Upper Arm Repair procedures
Removal
[Front Upper arm]
1.
Removal the front wheel & tire.
Tightening torque :
90.0 ~ 110.0 N.m(9.0 ~ 11.0 kgf.m, 65.0 ~ 80.0 lb-ft)
2.
Removal the air strut assembly.
(Refer ...
Cowl Cross Bar Assembly Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply prote ...