>
Removal |
1. |
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line") |
2. |
Turn the ignition switch OFF and disconnect the negative (-) battery cable. |
3. |
Folding the rear seat cushion. |
4. |
Remove the service cover (A) of the fuel pump after loosening the screws. |
5. |
Disconnect the fuel feed tube quick - connector (A). |
6. |
Remove the service cover of the canister (A) in trunk room. |
7. |
Disconnect the vapor tube quick-connector (A). |
8. |
Remove the rear - LH wheel, tire, and the inner wheel house, |
9. |
Disconnect the fuel tank extension connector (A), and then remove the wiring harness from the vehice. |
10. |
Lift the vehice. |
11. |
Remove the center muffler.
(Refer to Engine Mechanical System - "Muffler") |
12. |
Remove the under cover (A). |
13. |
Remove the propeller shaft.
(Refer to Driveshaft and acle - "Propeller Shaft Assembly") |
14. |
Disconnect the fuel filler hose (A) and leveling hose (B). |
15. |
Support the fuel tank with jack (A). |
16. |
Remove the fuel tank (B) from the vehicle arter removing the mounting nuts(A). |
Installation |
1. |
Install in the reverse order of removal.
|
Transmission Oil Temperature Sensor Schematic Diagrams
Circuit Diagram
...
Accelerator Pedal Description and Operation
Accelerator Pedal
Intelligent Accelerator Pedal (IAP) communicates with various modules by CAN communication.
IAP alarm the driver with foot power control and the vibration.Operation
...
Rear Console Cover Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply prote ...