>
Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the CCV connector. |
3. |
Measure resistance between the CCV terminal 1 and 2. |
4. |
Check that the resistance is within the specification.
|
5. |
Disconnect the vapor hose connected with the canister from the CCV. |
6. |
Connect a vacuum pump to the nipple. |
7. |
Ground the CCV control line and apply battery voltage to the CCV power supply line. |
8. |
Apply vacuum and check the valve operation.
|
Removal |
1. |
Turn the ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Remove the service cover (A). |
3. |
Disconnect the canister close valve connector (A). |
4. |
Disconnect the vapor hose (B) from the canister. |
5. |
Remove the installation bolt. |
6. |
Remove the canister close valve from the fuel tank air filter. |
Installation |
|
1. |
Install in the reverse order of removal.
|
Transmission Control Module (TCM) Description and Operation
Description
Transmission Control Module (TCM) is the automatic
Transmission's brain. The module receives and processes signals from
various sensors and implements a wide range of Transmission ...
Defroster
CAUTION
To prevent damage to the conductors bonded to the inside surface of the rear
window, never use sharp instruments or window cleaners containing abrasives to clean
the window.
✽ NOT ...
ESP OFF Switch Description and Operation
Description
1.
The ESP OFF switch is for the user to turn off the ESP system.
2.
The ESP OFF lamp is on when ESP OFF switch is engaged. ...