>
Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the OCV connector. |
3. |
Measure resistance between the OCV terminals 1 and 2. |
4. |
Check that the resistance is within the specification.
|
Removal |
1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Disconnect the CVVT oil control valve connector (A-Intake) and (B-Exhaust). |
3. |
Remove the mounting bolt, and then remove the valve from the engine. |
1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Disconnect the CVVT oil control valve connector (A-Intake) and (B-Exhaust). |
3. |
Remove the mounting bolt, and then remove the valve from the engine. |
Installation |
1. |
Installation is the reverse of removal.
[Connector Color]
|
Sedan Side Body
Side body A
Front side member tooling hole (O8)Fender apron panel tooling hole (O7)Front door hinge upper mounting hole (O13)Front door hinge lower mounting hole (O13) Fender mounting hole (O6.6 ...
Alignment Repair procedures
Wheel Alignment
When using commercially available computerized four wheel
alignment equipment (caster, camber, toe) to inspect the front wheel
alignment, always position the car on a level surf ...
Repair procedures
Adjustment
Glass Adjustment
•
Check the glass run channel for damage or deterioration, and replace them if necessary.
1.
Remove the front door trim.
(Refer to Fro ...