>
Removal |
1. |
Disconnect the battery negative (-) cable. |
2. |
Disconnect the battery sensor connector (A). |
3. |
Remove the battery negative (-) cable after removing the bolts (B). |
Installation |
1. |
Install in the reverse order of removal.
|
Center Control Panel (CCP) Repair procedures
Removal
Front Keyboard Unit
1.
Disconnect the negative (-) battery terminal.
2.
Remove the floor console upper cover.
(Refer to Body - "Floor console assembly")
3.
Disconnect the connect ...
8LR Brake Control Solenoid Valve Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
Intake Manifold Repair procedures
Removal and Installation
1.
Disconnect the negative terminal (A) from the battery.
Tightening torque :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
2.
Remove the engine room cover (A ...