Hyundai Equus: Oil Pressure Switch Repair procedures
Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Engine Mechanical System / Lubrication System / Oil Pressure Switch Repair procedures
Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Engine Mechanical System / Lubrication System / Oil Pressure Switch Repair procedures
| Inspection |
| 1. |
Check the continuity between the terminal and the body with an ohmmeter.
If there is no continuity, replace the oil pressure switch.
|
| 2. |
Check the continuity between the terminal and the body when
the fine wire is pushed. If there is continuity even when the fine wire
is pushed, replace the switch.
|
| 3. |
If there is no continuity when a 49.0kPa (0.5kg/cmx, 7.1psi)
is applied through the oil hole, the switch is operating properly.
Check for air leakage. If air leaks, the diaphragm is broken. Replace
it. |
Oil Pump Repair procedures
Removal
1.
Remove the sub frame.
(Refer to SS group)
2.
Drain engine oil.
(1)
Remove the oil filler cap.
(2)
After lifting the car, remove the oil drain plug and drain oil into a conta ...
See also:
Operating Door Locks From Outside the Vehicle
To lock the doors, press the button on the outside door handle while carrying
the Smart Key with you or press the Door Lock button on the Smart Key.
Put your hand in the driver’s outside door han ...
Center Control Panel (CCP) Components and Components Location
Components
...
General Information
The Micro 570 Analyzer
The Micro 570 Analyzer provides the ability to test the
charging and starting systems, including the battery, starter and
alternator.
x Because of ...
Categories
Hyundai Equus Manuals
© 2011-2024 Copyright www.heqmanual.com