>
1. With the glove box open, remove the stoppers on both sides to allow the glove box to hang freely on the hinges.
2. Remove the cylinder at the left of the glove box.
3. Remove the climate control air filter case pulling out both sides of the cover.
4. Replace the climate control air filter.
5. Reassemble in the reverse order of disassembly.
✽ NOTICE
When replacing the climate control air filter install it properly. Otherwise, the system may produce noise and the effectiveness of the filter may be reduced.
Crash Pad Side Cover Components and Components Location
Component Location
[LH]
1. Crash pad side cover [LH]
[RH]
1. Crash pad side cover [RH]
...
Wheel nut tightening torque:
Steel wheel & aluminum alloy wheel: 65~79 lb·ft (9~11 kg·m)
If you have a tire gauge, remove the valve cap and check the air pressure. If
the pressure is lower than recommended, drive slowly to ...
Compressor oil Repair procedures
Oil Specification
1.
The HFC-134a system requires synthetic (PAG) compressor oil
whereas the R-12 system requires mineral compressor oil. The two oils
must never be mixed.
2.
Compressor (P ...