>
1. Be sure the shift lever is in N (Neutral) or P (Park) and the emergency brake is set.
2. Check the battery connections to be sure they are clean and tight.
3. Turn on the interior light. If the light dims or goes out when you operate the starter, the battery is discharged.
4. Check the starter connections to be sure they are securely tightened.
5. Do not push or pull the vehicle to start it. See instructions for "Jump starting".
WARNING
If the engine will not start, do not push or pull the car to start it.This could result in a collision or cause other damage.
Trunk Lid Back Panel Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply prote ...
Advanced vehicle safety management (AVSM) (If equipped)
AVSM detects the distance from the vehicle ahead with the sensor, to warn you
before collision and protect you in certain hazardous situations by using warning
message, warning sound and seat belt ...
Engine number
The engine number is stamped on the engine block as shown in the drawing. ...