>
The hazard warning flasher serves as a warning to other drivers to exercise extreme caution when approaching, overtaking, or passing your vehicle.
It should be used whenever emergency repairs are being made or when the vehicle is stopped near the edge of a roadway.
Depress the flasher switch with the ignition switch in any position. The flasher switch is located in the center console switch panel. All turn signal lights will flash simultaneously.
Rear Seat Assembly Repair procedures
Replacement
[Rear Seat Cushion Assembly]
1.
Pull it up and remove the rear seat cushion assembly (A).
2.
Install in the reverse order of removal.
•
Make sure the co ...
GAWR (Gross axle weight rating)
This is the maximum allowable weight that can be carried by a single axle (front
or rear). These numbers are shown on the certification label. The total load on
each axle must never exceed its GAW ...
CVVT Oil Control Valve (OCV) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV terminals 1 and 2.
4.
Check that the resistance is within the specifi ...