>
To operate the LDWS, pull the switch with the Engine Start/Stop Button in the ON position. The indicator illuminates on the cluster. To cancel the LDWS, pull the switch again.
LDWS indicator light illuminates:
If your vehicle leaves the lane when the LDWS is operating and vehicle speed exceeds 43 mph (70 km/h), the warning operates as follows:
1. Visual warning
If you leave the lane, the lane you leave on the LCD display blinks yellow.
2. Auditory warning
If you leave the lane, the warning sound operates.
3. Tactual warning (if equipped with pre-safe seat belt)
If you leave the lane for about 3 seconds, the pre-safe seat belt provides haptic warning.
You can activate or deactivate this feature. Refer to "User Settings Mode" in chapter 4.
The LDWS does not operate when:
✽ NOTICE
To change lanes, operate the turn signal switch then change the lane.
Schematic Diagrams
Circuit Diagram
...
Thermostat Repair procedures
Removal and Installation
1.
Disconnect the negative terminal (A) from the battery.
Tightening torque :
4.0~6.0N.m (0.4~0.6kgf.m, 3.0~4.4lb-ft)
2.
Remove the air duct, air intak hose and ...
Tilt & Telescope Control (SCM) Repair procedures
Inspection
Ims Mode Setting With GDS
1.
You can turn ON/OFF of IMS tilt & telescope control option with the user option program.
2.
Select model and "body control module" menu.
3.
Sel ...