>
WARNING - Windshield heating
Do not use the or
position during cooling operation
in extremely humid weather. The difference between the temperature of the outside
air and that of the windshield could cause the outer surface of the windshield to
fog up, causing loss of visibility could cause an accident resulting in serious
injury or death. In this case, set the mode selection knob or button to the
position and fan speed control knob
or button to a lower speed.
✽ NOTICE
If the engine temperature is still cold after starting, then a brief engine warm up period may be required for the vented air flow to become warm or hot.
To defog inside windshield
1. Select desired fan speed.
2. Select desired temperature.
3. Press the defrost button ( ).
4. The outside (fresh) air position will be selected automatically.
If the outside (fresh) air position is not selected automatically, adjust the corresponding button manually.
If the position is selected, lower
fan speed is adjusted to a higher fan speed.
To defrost outside windshield
1. Set the fan speed to the highest (extreme right) position.
2. Set the temperature to the extreme hot (HI) position.
3. Press the defrost button ( ).
4. The outside (fresh) air position will be selected automatically.
If the position is selected, lower
fan speed is adjusted to a higher fan speed.
G Sensor Description and Operation
Description
There are a total of 3 acceleration sensors in the vehicle
that measure vehicle acceleration and communicate with the ECS ECU. The
ECS ECU calculates the vertical vibration speed, ...
Troubleshooting
Troubleshooting
SymptomProbable causeRemedyExcessive play in steeringLoose yoke plugRetightenLoose steering gear mounting boltsRetightenLoose or worn tie rod endRetighten or replace as necessaryS ...
Telemetics Unit (TMU) Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front AVN monitor.
(Refer to "Premium AVN System")
3.
Remove the MTS unit after loosening the screw and nuts.
4.
...