>

Hyundai Equus: Heater Control Unit Repair procedures

Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Heating, Ventilation and Air Conditioning / Controller / Heater Control Unit Repair procedures

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Remove the cowl side trim. (Refer to Body - "Cowl Side Trim")

3.	To remove the crash pad under cover [RH] (A), press both sides of the locking pin and then pull it down.

4.	Disconnect the under lamp connector (A).

5.	Remove the stopper (B) from the glove box (A).

6.	Disconnect the air damper (A) from the glove box (B).

7.	Remove the glove box housing (A) after loosening the mounting screws and nuts.

8.	Disconnect the glove box lamp connector (A).

9.	Remove the passenger's side shower duct (A).

10.	Unscrew the mounting srcrews and then remove the control unit (A).

11.	Install in the reverse order of removal.

Heater Control Unit Components and Components Location

Control Panel Component Connector Pin Function Pin No.Connector AConnector B1GroundIgnition 22-FET (Gate)3Mode Control Actuator (Vent)FET (Drain Feedback)4Mode Control Actuator (Defrost)Sen ...

See also:

Emergency Fastening Device (EFD) Description and Operation
Description The Emergency Fastening Device (EFD) operates at the same time with the Seat Belt Pretensioner when it satisifies the deployment condition after a collision. It is an auxiliary equi ...

Cylinder Block Components and Components Location
Components 1. Cylinder block bank cover2. Cylinder block bank cover gasket3. Cylinder block rear cover4. Cylinder block rear cover gasket5. Separator6. Drain plug7. O-ring8. Piston oil jet9. Chec ...

Rear Right Door Module (RRDM) Components and Components Location
Component ...

Categories

Hyundai Equus Manuals

© 2011-2024 Copyright www.heqmanual.com