>
Inspection |
1. |
Turn the ignition switch ON. |
2. |
Manually operate the control switch and measure the voltage of the blower motor. |
3. |
Select the control switch to raise the voltage until high speed.
Specification
|
4. |
If the measured voltage is not within specification, substitute with a known-good power mosfet and check for proper operation. |
5. |
Replace the power mosfet if it is proved that there is a problem with it. |
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the cowl side trim.
(Refer to Body - "Cowl Side Trim") |
3. |
To remove the crash pad under cover [RH] (A), press both sides of the locking pin and then pull it down. |
4. |
Disconnect the under lamp connector (A). |
5. |
Disconnect the power mosfet connector (A) and then remove the power mosfet (B) after loosening the mounting screws. |
6. |
Install in the reverse order of removal. |
Information Mode
Service Interval
This mode shows the service interval (mileage and days).
❈ For the setting of the service interval, refer to "User Settings Mode" of
the LCD display.
Service in
...
Description and Operation
Description
Front blind camera is a supplemental system that shows blind spot in front of the vehicle through the AV monitor.
The front blind camera will operate when you push the button
and shi ...
Components and Components Location
Component Location
1. AVN head unit2. Front LCD monitor3. Blue Link keyboard (Option)4. AUX jack5. Rear monitor spliter6. Steering wheel remote controller (SWRC)7. AVN rear keyboard8. External am ...