>
Inspection |
1. |
Connect the battery voltage and check the blower motor rotation. |
2. |
If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation. |
3. |
Replace the blower motor if it is proved that there is a problem with it.
|
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the cowl side trim.
(Refer to Body - "Cowl Side Trim") |
3. |
To remove the crash pad under cover [RH] (A), press both sides of the locking pin and then pull it down. |
4. |
Disconnect the under lamp connector (A). |
5. |
Disconnect the blower motor connector (A) and then remove the blower motor (B) after loosening the screws. |
6. |
Install in the reverse order of removal. |
Description and Operation
Description
The BSD (Blind Spot Detection) system uses a radar sensor to alert the driver while driving.
It senses the rear side territory of the vehicle and provides information to the driver.
- ...
Driving in the rain
Rain and wet roads can make driving dangerous, especially if you’re not prepared
for the slick pavement.
Here are a few things to consider when driving in the rain:
A heavy rainfall will ma ...
Fuel Pressure Control Valve Schematic Diagrams
Circuit Diagram
...