>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel") |
3. |
Remove the crash pad lower panel and then push the rear parking assist switch (A) to remove it.
|
Installation |
1. |
Install the rear parking assist switch after connecting the connector. |
2. |
Install the crash pad lower panel. |
Inspection |
1. |
Check that continuity exists between the terminals. If there is no continuity, replace the seat heater switch. |
Radiator Grill Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply prote ...
Fuel Tank Pressure Sensor (FTPS) Specifications
Specification
Pressure [kPa (kgf/cmx, in H2O)Output Voltage (V)-6.67 (-0.068, -26.8)0.502.5+6.67 (0.068, 26.8)4.5
...
Lighting control
The light switch has a Headlight and a Parking light position.
To operate the lights, turn the knob at the end of the control lever to one of
the following positions:
(1) OFF position
(2) Aut ...