>
The light switch has a Headlight and a Parking light position.
To operate the lights, turn the knob at the end of the control lever to one of the following positions:
(1) OFF position
(2) Auto light / AFLS position
(3) Parking light position
(4) Headlight position
Auto light/AFLS position
When the light switch is in the AUTO light position while the engine is running, the taillights and headlights will be turned ON or OFF automatically depending on the amount of light outside the vehicle.
If your vehicle is equipped with the adaptive front lighting system (AFLS), it will also operate when the headlamp is ON.
CAUTION
Parking light position ( )
When the light switch is in the parking light position, the tail, license and instrument panel lights are ON and the tail light indicator is ON.
Headlight position ( )
When the light switch is in the headlight position, the head, tail, license and instrument panel lights are ON.
✽ NOTICE
The Engine Start/Stop Button must be in the ON position to turn on the headlights.
EPB Switch Repair procedures
Removal
1.
Turn ignition switch off and disconnect the battery (-) cable from the battery
2.
Remove the driver side crash pad side cover.
(Refer to Body - "Crash Pad")
3.
Remove the cra ...
ETC (Electronic Throttle Control) System Description and Operation
Description
The Electronic Throttle Control (ETC) System consists of a
throttle body with an integrated control motor and throttle position
sensor (TPS). Instead of the traditional throttle cab ...
Output Speed Sensor Repair procedures
Inspection
1.
Check signal waveform of output speed sensor using the GDS.
Specification: Refer to "Signal Wave Form" section.
...