>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the height sensor linkage (A) installed on the front axle and rear axle.
(Number of height sensor : Air suspension - 4EA, Non-air suspension - 2EA)
[Front]
[Rear] |
3. |
Remove the height sensor assembly after disconnecting the connector.
[Front]
[Rear] |
4. |
Remove the height sensor unit (A) after removing screws(2EA).
[Front]
[Rear] |
Installation |
1. |
Install the height sensor unit. |
2. |
Install the height sensor assembly after connecting the connector. |
3. |
Install the height sensor linkage on the front axle and rear axle. |
4. |
Connect the negative (-) battery terminal. |
Over Pressure Valve (OPV) Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System -"Release Residual Pressu ...
Trunk room lamp
The trunk room lamp comes on when the trunk is opened.
CAUTION
The trunk room lamp comes on as long as the trunk lid opens. To prevent unnecessary
charging system drain, close the trunk lid se ...
Removing and storing the spare tire
Turn the tire hold-down wing bolt counterclockwise.
Store the tire in the reverse order of removal.
To prevent the spare tire and tools from “rattling” while the vehicle is in motion,
store th ...