In the state of IGN1 ON, when the multi function switch
module detects auto light switch on, tail lamp relay output and head
lamp low relay output are controlled according to the vertical and
horizontal auto light sensor's input.
If IGN1 ON, The BCM monitors the range of this supply and
raises up a failure as soon as the supply’s voltage is out of range.
Then this failure occurs and as long as this is present, the head lamp
must be turned on without taking care about the sunlight level provided
by the sensor.
This is designed to prevent any head lamp cut off when the failure occurs during the night.
Component Location
1. Auto light sensor2. Head lamps3. Lighting switch (Auto)4. Tail lamps5. IPM (Instrument Panel Module)
...
Inspection
In the state of IGN1 ON, when the multi function switch
module detects auto light switch on, tail lamp relay output and head
lamp low relay output are controlled according to auto li ...
See also:
Hood Latch Repair procedures
Replacement
1.
Remove the hood latch cover (A) mounting clip.
(Refer to Engine Mechanical System - "Active Air Flap(AAF)")
2.
Loosen the hood latch (B) mounting bolts.
Tightening torque : ...
Rail Pressure Sensor (RPS) Description and Operation
Description
Rail Pressure Sensor (RPS) is installed on the delivery pipe
and measures the instantaneous fuel pressure in the delivery pipe. The
sensing element (Semiconductor element) built in ...
1. Crankcase emission control system
The positive crankcase ventilation system is employed to prevent air pollution
caused by blow-by gases being emitted from the crankcase.
This system supplies fresh filtered air to the crankcase thr ...