>
Troubleshooting |
Symptom | Possible cause | Remedy |
One lamp does not light (all exterior) | Bulb or LED burned out | Replace bulb or lamp assembly |
Socket, wiring or ground faulty | Repair if necessary |
Head lamps do not light | Bulb or LED burned out | Replace bulb or lamp assembly |
Ignition fuse (LOW:10A, HIGH:20A) blown | Check for short and replace fuse |
Head lamp fuse (15A) blown | Check for short and replace fuse |
Lighting switch faulty | Check switch |
Wiring or ground faulty | Repair if necessary |
Tail lamps and license plate lamps do not light | Bulb or LED burned out | Replace bulb or lamp assembly |
Tail lamp fuse (10A) blown | Check for short and replace fuse |
Lighting switch faulty | Check switch |
Wiring or ground faulty | Repair if necessary |
Stop lamps do not light | Bulb or LED burned out | Replace bulb or lamp assembly |
Stop lamp fuse (15A) blown | Check for short and replace fuse |
Stop lamp switch faulty | Adjust or replace switch |
Wiring or ground faulty | Repair if necessary |
Stop lamps do not turn off | Stop lamp switch faulty | Repair or replace switch |
Instrument lamps do not light (Tail lamps light) | Rheostat faulty | Check rheostat |
Wiring or ground faulty | Repair if necessary |
Turn signal lamp does not flash on one side | Bulb or LED burned out | Replace bulb or lamp assembly |
Turn signal switch faulty | Check switch |
Wiring or ground faulty | Repair if necessary |
Turn signal lamps do not light | Bulb or LED burned out | Replace bulb or lamp assembly |
Turn signal lamp fuse (10A) blown | Check for short and replace fuse |
Turn signal switch faulty | Check switch |
Wiring or ground faulty | Repair if necessary |
Hazard warning lamps do not light | Bulb or LED burned out | Replace bulb or lamp assembly |
Hazard warning lamp fuse (15A) blown | Check for short and replace fuse |
Hazard switch faulty | Check switch |
Wiring or ground faulty | Repair if necessary |
Flasher rate too slow or too fast | Lamps' wattages are smaller or larger than specified | Replace lamps |
Back up lamps do not light | Bulb or LED burned out | Replace bulb or lamp assembly |
Back up lamp fuse (10A) blown | Check for short and replace fuse |
Back up lamp switch (M/T) faulty | Check switch |
Transaxle range switch (A/T) faulty | Check switch |
Wiring or ground faulty | Repair if necessary |
Room lamp does not light | Bulb or LED burned out | Replace bulb or lamp assembly |
Room lamp fuse (10A) blown | Check for short and replace fuse |
Room lamp switch faulty | Check switch |
Wiring or ground faulty | Repair if necessary |
Front fog lamps do not light | Bulb or LED burned out | Replace bulb or lamp assembly |
Front fog lamp fuse (15A) blown | Check for short and replace fuse |
Front fog lamp switch faulty | Check switch |
Wiring or ground faulty | Repair if necessary |
Map lamp does not light | Bulb or LED burned out | Replace bulb or lamp assembly |
Room lamp fuse (10A) blown | Check for short and replace fuse |
Map lamp switch faulty | Check switch |
Wiring or ground faulty | Repair if necessary |
Trunk room lamp does not light | Bulb or LED burned out | Replace bulb or lamp assembly |
Room lamp fuse (10A) blown | Check for short and replace fuse |
Trunk room lamp switch faulty | Check switch |
Wiring or ground faulty | Repair if necessary |
Steering Wheel Remote Controller (SWRC) Troubleshooting
Initialization and Troubleshooting Procedures
1.
Initialization Procedure
: Disconnect (connector or battery) for 30 seconds (time required for internal condenser discharge), then reconnect the p ...
Special Service Tools
Special Service Tools
Tool (Number and Name)IllustrationUse09561-11001Steering wheel pullerRemoval of steering wheel
...
Power Door Lock Actuators Repair procedures
Inspection
Front Door Lock Module Inspection
1.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
2.
Remove the front door module.
(Refer to Body - "Front Door Module")
3.
...