>
Inspection |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the lower crash panel and then disconnect the rheostat connector. |
3. |
Check for intensity of new rheostat switch. If the light
intensity of the lamps changes smoothly without any flickering when the
rheostat is turned, it can be assumed that the rheostat is normal. |
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the lower crash panel (A).
(Refer to Body - "Crash Pad Lower Pannel") |
3. |
Remove the crash pad switch assembly (A) after loosening the screws. |
4. |
Remove the rheeostat switch assembly (A) from lower crash panel. |
Installation |
1. |
Install the rheostat switch to the switch assembly. |
2. |
Install the switch assembly. |
3. |
Install the lower crash panel. |
Components and Components Location
Components
1. BSD (Blind Spot Detection) switch module (ON/OFF switch & state LED)2. Speaker (Built in the cluster)3. Head Up Display (HUD)4. BSD warning lamp (Built in the outside mirror)5. ...
Front Door Inside Handle Repair procedures
Replacement
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
Disconnect the front door inside handle lamp connector (A).
3.
After loosening the mounting screws ...
Bulb wattage
...