>
Inspection |
1. |
Turn the ignition key to the "ON" position. |
2. |
Cover the front looking sensor to stop functioning. |
3. |
Head a light to the rearward looking sensor. |
4. |
The ECM should be darkened as soon as the rearward looking sensor detects the light.
|
5. |
When the reverse gear is engaged, the ECM should not be darkened.
When heading lights to both the front looking and rearward looking sensors, the ECM should not be darkened. |
Removal |
1. |
Remove the mirror wiring cover (A). |
2. |
Remove the connector (B). |
3. |
Push the inside rear view mirror base up to remove the inside rear view mirror assembly (A) after removing the screw.
|
Installation |
1. |
Install the mirror assembly. |
2. |
Install the mirror wiring cover and connector. |
Brake Pedal Repair procedures
Removal
1.
Remove the lower crash pad.
(Refer to Body - "Crash Pad")
2.
Disconnect the stop lamp switch connector (A).
3.
Remove the mounting bracket nut (B).
Tightening torque :
14. ...
Blind Spot Detection Indicator Repair procedures
Removal
Blind Spot Detection Warnig Indicator
1.
Disconnect the negative (-) battery terminal.
2.
Remove the mirro (A).
Installation
Blind Spot Detection Warnig Indicator
1.
Install the ...
Smart cruise control vehicle to vehicle distance
To set vehicle to vehicle distance:
This function allows you to program the vehicle to maintain relative distance
to the vehicle ahead without depressing the accelerator pedal or brake pedal.
...