>
Removal |
The dust or foreign substance on the rain sensor have a bad
effect upon the rain sensor capability,so protect the sensor surface
with protection cover until installing the rain sensor to bracket for
accurate funtion.
The coupling pad on the rain sensor surface has adherive
strength, so the coupling pad could stick to the windshield by
environment condition during the using time.
If separate it by force, it could be damaged. So make sure to separate the rain sensor from the windshield carefully. |
1. |
Remove the rain sensor and LDWS unit cover (A) first. |
2. |
Remove the wiring harness connector from sensor. |
3. |
Be careful not to damage the cover latch by applying
excessive force. To remove the rainsensor, pull aside the latch bracket
hele with a small flat - blade screwdriver (A). |
4. |
Rain sensor module is attached to the front windshield by
glue replacing the front windshield, remove the rain sensor module from
the existing front windshield and install on the new front windshield. |
Installation |
|
1. |
Install the rainsensor bracket to the windshield glass using the tape.
|
2. |
Connect the rainsensor connector, and then install the sensor cover. |
Immobilizer system
The immobilizer system protects your vehicle from theft. If an improperly coded
key (or other device) is used, the engine’s fuel system is disabled.
When the Engine Start/Stop Button is in the ON p ...
LCD Display Control
The LCD display modes can be changed by using the control buttons on the steering
wheel.
(1) button : Changing LCD modes
(right to left), or returning to previous position
(2) button : Chan ...
Power Mirror Switch Repair procedures
Inspection
1.
The DDM inputs can be checked using the GDS.
2.
To check the input value of door lock switch, select option "IPM".
3.
Select option "DDM (Driver Door Module)".
4.
Select ...