>
Removal |
|
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front bumper cover.
(Refer to Body - "Front Bumper") |
3. |
Remove the front head lamp assembly.
(Refer to Lighting System / Head Lamp) |
4. |
Remove the washer hose and the washer motor connector (A) and the washer fluid level sensor connector (B). |
5. |
Remove the washer reservoir 2 bolts. |
6. |
Remove the mounting bolts of air suspension reserive tank
under the washer reserive in order to make easier to remove washer tank.
But, do not disconnect air hose.
(Refer to Suspension - "Front Suspension System") |
7. |
Remove the washer reserior after loosening the mounting bolt from the lower and of washer reserivor |
Inspection |
1. |
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
|
2. |
Connect positive (+) battery cables to terminal 2 and negative (-) battery cables to terminal 1 respectively. |
3. |
Check that the motor operates normally and the washer motor runs and water sprays from the front nozzles. |
4. |
If they are abnormal, replace the washer motor.
(Connector NO.1 : Windshield washer (+), 2: Ground) |
1. |
Disconnect the negative(-) battery terminal. |
2. |
Drain the washer fluid less than 650 cc. |
3. |
Check for continuity between the No. 1 and No.2 terminal in each float position.
There should be continuity when the float is down.
There should be no continuity when the folat is up. |
4. |
If the continuity is not as specified, replace the washer fluid level switch |
1. |
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
|
2. |
Connect positive (+) battery cables to terminal 2 and negative (-) battery cables to terminal 1 respectively. |
3. |
Check that the motor operates normally and the washer motor runs and water sprays from the head lamp nozzles. |
4. |
If they are abnormal, replace the washer motor. |
Installation |
1. |
Install the washer reservoir.
|
2. |
Install the washer motor hose and connectors. |
3. |
Install the air suspension reserve tank bolts. |
4. |
Install the head lamp assembly. |
5. |
Install the front bumper cover. |
LCD Display Control
The LCD display modes can be changed by using the control buttons on the steering
wheel.
(1) button : Changing LCD modes
(right to left), or returning to previous position
(2) button : Chan ...
3. Exhaust emission control system
The Exhaust Emission Control System is a highly effective system which controls
exhaust emissions while maintaining good vehicle performance.
Vehicle modifications
This vehicle should not be mo ...
Troubleshooting
Troubleshooting
1.
After replacing multi-view camera unit, always check that the system operates properly.
2.
If the failure persists after replacing the multi-view camer ...